Best Cam For A Stock 302
Review Of Best Cam For A Stock 302 Ideas. Stick a hot cam in a stock engine with stock. It may be a little challenging to install.
I have a 1968 stock 302 motor with the edelbrock rpm performer intake and holley 600 cfm carb. But don’t think that adding a bigger camshaft will make more power. Stick a hot cam in a stock engine with stock.
All Depends On The Valve Springs You Put In Those.
It did have a 4 spd and 4:63 gears. This cam can be used with the stock converter which means it should be relatively mild but was designed to have a rougher than stock idle. Stick a hot cam in a stock engine with stock.
This Lets The Spark Plug Wires Exit Through The Side Of The Distributor Cap, Which Helps To Lower The Overall Height.
It may be a little challenging to install. Maybe a bit differt only to blow off some compression which stock is 10.5 advertized. But don’t think that adding a bigger camshaft will make more power.
A Simple Trick When Installing A Camshaft Into A 302 Or 351 Is To Carefully Place A Philips Head Screw Driver Into The Front Of The Cam.
This will help allow for better control when. A good rv cam with a high lift and short duration is what you need for. I bumped the cam to a crower hyd 572 lift.
I Run Stock Cams In All My Turbo 5.0',S As I Want Good Mileage And Low Speed Response.
I want some expert advice on adding a cam. Realy the best cam for stock componets is going to be perty much like the factory cam. I have a 1968 stock 302 motor with the edelbrock rpm performer intake and holley 600 cfm carb.
Cam, Intake And Heads Have To Be Matched To The Type Of Driving And Use Of The Car.
Any cam besides the stock piece will sacrifice low rpm power for more top end, that',s life with the 5.0.
Post a Comment for "Best Cam For A Stock 302"